Skynet Skynet error USB not found after USB drive substitution.

[bigAboo]

Hello. I remove my old drive and put new USB flash to usb3.0 port on my RT-AC68U. In "amtm" menu I see

When I hit 2 i see

and so on...
How can I solve this installation problem?

 

[nbdwt73]

Hello. I remove my old drive and put new USB flash to usb3.0 port on my RT-AC68U. In "amtm" menu I see
View attachment 30453
When I hit 2 i see
View attachment 30454
and so on...
How can I solve this installation problem?

Did you format the new thumb drive before inserting it? If not then format on your computer then try again...

 

[JaimeZX]

Skynet was installed on your thumbdrive. If you remove the thumbdrive and put a different one, then Skynet isn't there anymore.

 

[bigAboo]

Yes, I'

Did you format the new thumb drive before inserting it? If not then format on your computer then try again...

Yes, i've format new drive, then make swap, then install Entware. And from the begining before all this steps amtm shows me that Skynet is installed.(

 

[bigAboo]

Skynet was installed on your thumbdrive. If you remove the thumbdrive and put a different one, then Skynet isn't there anymore.

I though just like You but, but nope amtm shows me that Skynet is installed. This fact confuse me.

 

[francovilar]

Administration, system and format jffs at next boot. The intention was to start over for scripts, correct?

 

[bigAboo]

Administration, system and format jffs at next boot. The intention was to start over for scripts, correct?

Yeap), did that trick too. Skynet still there.

 

[francovilar]

Yeap), did that trick too. Skynet still there.

Sorry for the basic troubleshooting but did you press apply and reboot the router?

 

[bigAboo]

Sorry for the basic troubleshooting but did you press apply and reboot the router?

of course couple of times

 

[JaimeZX]

Then I think your next move is to perform a full M&M Reset. ( @L&LD has detailed the procedures a number of times.)

Edit: link - https://www.snbforums.com/threads/n...l-and-manual-configuration.27115/#post-205573

 

[thelonelycoder]

amtm looks for the file /jffs/scripts/firewall to determine if Skynet is installed.

 

[Belmy]

Then I think your next move is to perform a full M&M Reset. ( @L&LD has detailed the procedures a number of times.)

of course couple of times

I think you need to do

firewall uninstall (then the old USB will be not recognized and Skynet will dissapear from AMTM menu)

 

[Belmy]

I think you need to do

firewall uninstall (then the old USB will be not recognized and Skynet will dissapear from AMTM menu)

It was seen in a post from @agilani
Skynet - Skynet: [*] USB Not Found - Sleeping For 10 Seconds ( Attempt 1 Of 10 ) | SmallNetBuilder Forums (snbforums.com)

 

[Diamond67]

I though just like You but, but nope amtm shows me that Skynet is installed. This fact confuse me.

You have to uninstall Skynet

sh /jffs/scripts/firewall uninstall

Then install it again.

 

[bigAboo]

You have to uninstall Skynet

sh /jffs/scripts/firewall uninstall

Then install it again.

Bravo!)) Many thanx!
That worked for me perfect.
Close the thread.