mixja
New Around Here
I experienced a short disconnection on my WAN connection, it was approximately 1-2 minutes and the PPPoE connection didn't actually drop, just Internet connectivity.
I got this logging information at the time of the event:
# Enable direct rule if not tunnelled (C2D)
stop_nat_rules: apply the redirect_rules!
[569 wanduck:start_dnsmasq +240457] begin
[569 wanduck:stop_dnsmasq +240457] begin
[1 preinit:init_main +240457] main loop signal/state=14
[569 wanduck:stop_dnsmasq +240457] end
[569 wanduck:start_dnsmasq +240457] end
[1 preinit:init_main +240457] main loop signal/state=14
# Disable direct rule if not tunnelled (D2C)
start_nat_rules: apply the nat_rules(/tmp/nat_rules_ppp0_vlan10)!
[569 wanduck:start_dnsmasq +240461] begin
[569 wanduck:stop_dnsmasq +240461] begin
[1 preinit:init_main +240461] main loop signal/state=14
[569 wanduck:stop_dnsmasq +240461] end
[569 wanduck:start_dnsmasq +240461] end
Any ideas on this?
I got this logging information at the time of the event:
# Enable direct rule if not tunnelled (C2D)
stop_nat_rules: apply the redirect_rules!
[569 wanduck:start_dnsmasq +240457] begin
[569 wanduck:stop_dnsmasq +240457] begin
[1 preinit:init_main +240457] main loop signal/state=14
[569 wanduck:stop_dnsmasq +240457] end
[569 wanduck:start_dnsmasq +240457] end
[1 preinit:init_main +240457] main loop signal/state=14
# Disable direct rule if not tunnelled (D2C)
start_nat_rules: apply the nat_rules(/tmp/nat_rules_ppp0_vlan10)!
[569 wanduck:start_dnsmasq +240461] begin
[569 wanduck:stop_dnsmasq +240461] begin
[1 preinit:init_main +240461] main loop signal/state=14
[569 wanduck:stop_dnsmasq +240461] end
[569 wanduck:start_dnsmasq +240461] end
Any ideas on this?