johny_2000
Occasional Visitor
After the last firmware update to 3.0.0.4.388_22068 I reset my XT8 AiMesh system to factory settings with WPS button method, and for the first few days I saw all the statistics on the AiMesh -> Node -> Network page, including 'Backhaul Information' PHY rate in Transmit / Receive XXXX Mbps.
A few days later, I noticed that the mesh connection had been reset 17 hours ago, and when I looked at the node's network page, I saw zeros in the Transmit / Receive PHY rate.
Since then, I have restarted both devices several times, but have not been able to restore the PHY rate statistics again.
Is there any way to fix this without factory reset again?
P.S. The data rate of 'Fronthaul Information' is always displayed fine.
See attached screenshots.
A few days later, I noticed that the mesh connection had been reset 17 hours ago, and when I looked at the node's network page, I saw zeros in the Transmit / Receive PHY rate.
Since then, I have restarted both devices several times, but have not been able to restore the PHY rate statistics again.
Is there any way to fix this without factory reset again?
P.S. The data rate of 'Fronthaul Information' is always displayed fine.
See attached screenshots.
Attachments
Last edited: