Recent content by EMERSON VIER

I have been updating my device with every version, not jumping from 386.9 to 386.12, and never did a full reset on my device.

My WiFi is connected but there is no Internet, the cable is still working well, I have had it since the 386.9, now 386.12 any suggestions, please.... *Edit - I have been updating my device by every version, not jumping from 386.9 to 386.12, and never did a full reset on my device. Enable...

Hi all, I am looking for some solution to use RT-AC86U by POE, by the switch is hard to because the voltage provide is around 48Vcc, on the RT-AC86U power supply I saw the spec 19Vcc/1.75Amps, then I bought, POE injector, but the problems are the size of the power connector, the RT-AC86U is 4.00...

Hi all, I have one RT-AC86U on first floor but on the second floor 5Hz is too weak, I think about to add other router on the second floor so I have two questions: 1 Recommendation for a new router? 2 AiMesh or Cable to connect to second router? Thank you. Vier

Hi folks, thank all of you, after to many hours.... I did over SSH(Putty), run the "nvram erase" command so works ;). After reboot many time and power off/on many times. I hope I fixed on your tips. Only one thing still bad, I have 3 devices 2.4 but I can not connect.

I did this to many times, but the last three I did manually, so I am only set up the wifi.

Hi folks, If remove power from my AC86U, and apply power again, take more then 2 hours to the router will be back to work, I did a factory reset by the webpage, set up again, issues still, I tried Reset 30-30-30 but does not work, after router go back with the same configuration. I have the FW...

Hi Dave, I am new on Merlin just moved from DDWRT, I bought AC86U for 4 months ago, I remember on first days to set up, I saw clients.

Hi I can not see Clients Status, on icon show 0, when I click on Button show Searching, please wait...after few seconds show No data in table. RT-AC86U 384.8_2

I have QNAP TS251+, and bought RT-86U a few days ago, install the Merlin but have a problem with Web connectivity. My UPnP on Router is enabled. So I added Port Forwarding, but still in the same way.