I always keep my firmware up to date and recently updated to version 3.0.0.4.382_50470
However I found that for some reason I was unable to log into WAN administration
Looking into things it would appear that at some point recently the config only always HTTPS, this certainly was not the case when I last used it some to earlier this year. Also I found that I had to change the port as it still reports that the port I normally use is already in use.
I have also found since the latest upgrade that the router is not as stable as it has been of late.
When I get a free weekend I will clear NVRAM and configure fresh but I thought I would just share my experience and see if anyone else has noticed this
However I found that for some reason I was unable to log into WAN administration
Looking into things it would appear that at some point recently the config only always HTTPS, this certainly was not the case when I last used it some to earlier this year. Also I found that I had to change the port as it still reports that the port I normally use is already in use.
I have also found since the latest upgrade that the router is not as stable as it has been of late.
When I get a free weekend I will clear NVRAM and configure fresh but I thought I would just share my experience and see if anyone else has noticed this