AC3100 AP Isolation

[KikoJ]

Have an AC3100 set up as an AP. Single SSID for both 2.4 and 5.

Problem is I cannot consistently communicate between wireless clients.

It acts as if AP isolation is enabled. In Wireless|Professional for each band Set AP Isolated is not enabled.

Is there something else preventing wireless clients from communicating to each other? I can ping a wireless device successfully from a wired connection but not from a wireless one.

Thoughts?

 

[ToddH]

I'm having the exact same problem after updating my firmware on my AC5300. I also checked the AP isolation as that is exactly how it is acting. Its a problem for me with a wireless printer that now is completely useless. I have a ticket open with ASUS and I'm going to restore factory defaults and re-apply the latest firmware to see if that helps. I just haven't had the time to take my network down yet.

 

[L&LD]

I'm going to restore factory defaults and re-apply the latest firmware to see if that helps.

First flash the firmware you want to use. Then do a full reset to factory defaults.

http://www.snbforums.com/threads/no...l-and-manual-configuration.27115/#post-205573

http://www.snbforums.com/threads/rt-ac66u-slow-wan-to-lan.12973/page-3#post-269410

http://www.snbforums.com/threads/faq-nvram-and-factory-default-reset.22822/