What's new

RT-AC86U network drops when using syncthing or soulseek

  • SNBForums Code of Conduct

    SNBForums is a community for everyone, no matter what their level of experience.

    Please be tolerant and patient of others, especially newcomers. We are all here to share and learn!

    The rules are simple: Be patient, be nice, be helpful or be gone!

SanPe

Occasional Visitor
Hi guys,

Basically what the title says. I need help to troubleshoot an issue with network drops.
I run syncthing on my desktop pc, on a sbc (Odroid C2). Everything's fine.
When I launch the app on my android phone, after a couple of seconds, the wifi crashes, then comes back online after 10 seconds, and crashes again. The issue resolve itself if I close syncthing on my phone.

The issue is the same when I'm using soulseek on my phone (wifi crashes) but same goes for soulseek on my desktop Ethernet wired computer: network goes dark after soulseek is launched, then it comes back.

I don't really understand the logs, but I can post it if it's needed.
I'm running latest merlin (stable). UPnP is activated.

Thanks!
 
Ok. Here's /tmp/syslog.log.
I started syncthing on my phone at May 14th, 06:34 PM.
13:39:01 was latest line on log before I started syncthing.
Right after, router crashed, and time and date went back to May 5th, 7:05 AM.

Code:
May 14 13:39:01 ovpn-server1[2374]: Connection Attempt read UDPv4 [CMSG=8|ECONNREFUSED]: Connection refused (fd=10,code=111)
May  5 07:05:05 kernel: nand: Could not find valid ONFI parameter page; aborting
May  5 07:05:05 kernel: brcmboard registered
May  5 07:05:05 kernel: genirq: Flags mismatch irq 36. 00000000 (brcm_36) vs. 00000000 (brcm_36)
May  5 07:05:05 kernel: pci 0000:00:00.0: of_irq_parse_pci() failed with rc=-22
May  5 07:05:05 kernel: pci 0000:01:00.0: of_irq_parse_pci() failed with rc=-22
May  5 07:05:05 kernel: pci 0001:00:00.0: of_irq_parse_pci() failed with rc=-22
May  5 07:05:05 kernel: pci 0001:01:00.0: of_irq_parse_pci() failed with rc=-22
May  5 07:05:05 kernel: broadcomThermalDrv brcm-therm: init (CPU count 2 2 2 2)
May  5 07:05:05 kernel: eth1 (Ext switch port: 0) (Logical Port: 8) Link UP 1000 mbps full duplex
May  5 07:05:05 kernel: eth2 (Ext switch port: 1) (Logical Port: 9) Link UP 1000 mbps full duplex
May  5 07:05:05 kernel: eth3 (Ext switch port: 2) (Logical Port: 10) Link UP 1000 mbps full duplex
May  5 07:05:05 kernel: eth4 (Ext switch port: 3) (Logical Port: 11) Link UP 1000 mbps full duplex
May  5 07:05:05 kernel: eth1 (Ext switch port: 0) (Logical Port: 8) Link DOWN.
May  5 07:05:05 kernel: eth2 (Ext switch port: 1) (Logical Port: 9) Link DOWN.
May  5 07:05:05 kernel: eth3 (Ext switch port: 2) (Logical Port: 10) Link DOWN.
May  5 07:05:05 kernel: eth4 (Ext switch port: 3) (Logical Port: 11) Link DOWN.
May  5 07:05:05 kernel: eth3 (Ext switch port: 2) (Logical Port: 10) Link UP 1000 mbps full duplex
May  5 07:05:05 kernel: eth1 (Ext switch port: 0) (Logical Port: 8) Link UP 1000 mbps full duplex
May  5 07:05:05 kernel: eth2 (Ext switch port: 1) (Logical Port: 9) Link UP 1000 mbps full duplex
May  5 07:05:05 kernel: eth0 (Int switch port: 3) (Logical Port: 3) Link UP 1000 mbps full duplex
May  5 07:05:05 kernel: eth4 (Ext switch port: 3) (Logical Port: 11) Link UP 1000 mbps full duplex
May  5 07:05:05 kernel: hub 1-0:1.0: config failed, hub doesn't have any ports! (err -19)
May  5 07:05:09 acsd: selected channel spec: 0x1009 (9)
May  5 07:05:09 acsd: Adjusted channel spec: 0x1009 (9)
May  5 07:05:09 acsd: selected channel spec: 0x1009 (9)
May  5 07:05:09 acsd: acs_set_chspec: 0x1009 (9) for reason APCS_INIT
May  5 07:05:09 acsd: selected channel spec: 0xe02a (36/80)
May  5 07:05:09 acsd: Adjusted channel spec: 0xe02a (36/80)
May  5 07:05:09 acsd: selected channel spec: 0xe02a (36/80)
May  5 07:05:09 acsd: acs_set_chspec: 0xe02a (36/80) for reason APCS_INIT
May  5 07:05:10 Mastiff: init
May 14 18:34:44 kernel: EXT4-fs error (device sda1): ext4_mb_generate_buddy:757: group 2, block bitmap and bg descriptor inconsistent: 12484 vs 12485 free clusters
May 14 18:34:52 statd[7670]: Failed to open directory sm: No such file or directory
May 14 18:35:12 crond[1201]: time disparity of 3170130 minutes detected

Is there another logfile that can help? Because I'm not sure that this can help :(
 

Similar threads

Latest threads

Sign Up For SNBForums Daily Digest

Get an update of what's new every day delivered to your mailbox. Sign up here!
Top