script VPN Client goes down

[schranzc]

Hello,

I know the script "openvpn-event" which is called whenever the OpenVPN-Client connects (or VPN-Server connects or go down) - but is there a way to run a script if OpenVPN-Client goes down?

Thank you so much!

 

[RMerlin]

updown.sh is called on --up and --down, and in turns it also calls openvpn-event.

There are other script hooks in OpenVPN, check the man page in case --down doesn't get called on a pure disconnect (rather than the client being manually stopped).

 

[schranzc]

I don't know what I should do Where should I add the file "updown.sh"? In "/jffs/scripts/"? - doesn't work

 

[RMerlin]

I don't know what I should do Where should I add the file "updown.sh"? In "/jffs/scripts/"? - doesn't work

updown.sh is what the firmware uses internally, you cannot replace it. That script will call openvpn-event, which is the one you can create to put your own code in it.

 

[peraburek]

Hello,

I know the script "openvpn-event" which is called whenever the OpenVPN-Client connects (or VPN-Server connects or go down) - but is there a way to run a script if OpenVPN-Client goes down?

Thank you so much!

https://tunnelblick.net/cUsingScripts.html

route-up is executed after connection authentication, either immediately after, or some number of seconds after as defined by the --route-delay option.
route-pre-down is executed right before the routes are removed.
down is executed after TCP/UDP and TUN/TAP close.

you have sample script /jffs/scripts/vpn-route-1.sh check link below, adjust it to your need
http://www.snbforums.com/threads/de...-usual-with-asuswrt-merlin.31415/#post-253228