Hi,
I did search before posting this but couldn't seem to find the same issue.
When I have setup the client using the service config file I then use the director to enable it for 1 device only.
1. Once I have enabled the WireGuard client, it seems the Router itself then uses the VPN rather than WAN. Example, I use a US WireGuard from UK, once I enable the client Pings on the dashboard spike from 5-8ms up to 90-130ms.
2. With the WireGuard client activated I could see in the router logs that the WAN was dropping up to 12 times an hour and restoring connection within 6l7 seconds each time.
What is causing this? Do I need to change the AllowedIPs under Peer to just that one device I want to use the VPN or leave it as 0.0.0.0/0?
Thanks
I did search before posting this but couldn't seem to find the same issue.
When I have setup the client using the service config file I then use the director to enable it for 1 device only.
1. Once I have enabled the WireGuard client, it seems the Router itself then uses the VPN rather than WAN. Example, I use a US WireGuard from UK, once I enable the client Pings on the dashboard spike from 5-8ms up to 90-130ms.
2. With the WireGuard client activated I could see in the router logs that the WAN was dropping up to 12 times an hour and restoring connection within 6l7 seconds each time.
What is causing this? Do I need to change the AllowedIPs under Peer to just that one device I want to use the VPN or leave it as 0.0.0.0/0?
Thanks