Release Asuswrt-Merlin 3006.102.6 is now available

[charlesb224]

I bit the bullet last week on a new rt-be92u from UK Currys (£169). Came on Friday, I immediately put this latest firmware on and then setup mostly from scratch, I copied some of the NVRAM pieces over (Wireguard Server/Clients, DHCP reservations and names). It was working fine, although coming from a rt-ax92u, I noticed it is quite laggy on the webGui, with pages not always refreshing.

The strangest thing was I set a 1am Sunday reboot. I was up early and found no internet. I logged into the router at 5:11am and was surprised as it had an assigned WAN address from the ISP, so it was either routing table not updated or something else. PPPoE connection directly to a ONT over ethernet.
a restart of the WAN (click WAN on/off in Gui) fixed it.
See attached logs. I have obfuscated mac/ip/usernames

Any ideas on cause. I have disabled auto-reboot for now.

 

[Ripshod]

Disable IPv6 in your DDNS settings and reboot.

 

[charlesb224]

Disable IPv6 in your DDNS settings and reboot.

I saw that ipv6 was having issues, but I'm puzzled why this would stop all routing of IPv4 traffic.

 

[Poul Bak]

Thanks Ill start doing that. However, issue returned this morning. Windows 11 most up to date devices are not consistently being shown when connected to 6Ghz bands. I can go in and force a refresh and they come back for a bit but then they disappear again after a while. Not sure what's causing the issue but Ill like have to roll back a couple versions to check the behavior. I don't see anything in the debug log to indicate what's happening.

I have seen the same on BT10 (stock!!).
My investigations:
You have a multi-band network (5 and 6GHz)
You have disabled MLO completely (on 'Wireless', 'MLO').

If I enable MLO globally (on 'Wireless', 'MLO'). then they are shown correctly.
Note: You don't need to enable MLO backhaul on ANY networks.

Please try that and report back.
I think Asus is so keen on MLO that they have forgotten not everybody uses it.