Hi All,
I have a house and shop setup on opposite ends of my acreage. A while back, I asked for ideas on how to connect them, and wound up buying Engenius EOC2611s for bridging. I'm new to this, and I'm just not sure how to get them setup properly.
I have a (cable company supplied) cisco modem/router at my house. I plugged one of the 2611s into it, and set it up as an access point with a unique SSID. At my shop, I have the other 2611 setup as a client bridge, hooked to an old WRT54G. I have the bridge connected to the access point, but can't get internet access through the WRT54G.
I know that it's a config problem, but I don't know how the IPs, DHCP and the like are supposed to look. Any advice would be greatly appreciated.
I have a house and shop setup on opposite ends of my acreage. A while back, I asked for ideas on how to connect them, and wound up buying Engenius EOC2611s for bridging. I'm new to this, and I'm just not sure how to get them setup properly.
I have a (cable company supplied) cisco modem/router at my house. I plugged one of the 2611s into it, and set it up as an access point with a unique SSID. At my shop, I have the other 2611 setup as a client bridge, hooked to an old WRT54G. I have the bridge connected to the access point, but can't get internet access through the WRT54G.
I know that it's a config problem, but I don't know how the IPs, DHCP and the like are supposed to look. Any advice would be greatly appreciated.