Wireless Report AiMesh v1.5.1 [2026-Apr-19] - WebGUI Table of all AiMesh connected devices (available in AMTM!)

[JB_1366]

v1.5.0-saves current column state on all tables on refresh. thx @scootertramp for testing.

 

[JB_1366]

v1.5.1-Added new device detection-the entire device row 'pulses' on new device detected. it checks known_macs.db located in your usb_path. If you ever want to start over, delete that file, your whole report will pulse. or you could delete any mac you want, to see it pulse.

 

[JGrana]

The pulsing works well. I deleted a few clients in the known_macs.db and they did show a slow pulse on the next scan. Then “unpulsed” after the following scan.
Very useful when adding new devices!

One comment - on the initial install/scan don’t pulse. I did a complete uninstall then install via amtm. When I went to the wireless report - they were all pulsing.
Just a recommendation.

 

[Untried3868]

Is there an SSID character limit in WR? I ask because it's cutting off the last character (16 17) of my SSID.

Edit: Correction, 17 characters. Math is hard apparently.

 

[jksmurf]

Is there an SSID character limit in WR? I ask because it's cutting off the last character (16) of my SSID.

Yep. It used to be even shorter, around 10, following an offline discussion with @JB_1366 I think it went to 15, but was never actually published AFAIK.

Whilst that field can go up to 32 on your router, it does make sense to cap it at some lower figure that doesn’t cause havoc with the other columns. I can’t see it getting even close to 32.

 

[ComputerSteve]

So this is a great script @JB_1366 !!
- do you think you can enhance it to actually transition or kick devices that seem to get stuck - Roaming assistant stinks =( It never actually does the kicking of certain devices - even with the threshold set to obscenely low numbers or vice versa very high numbers. I created on each node a script that would issue a bss transition and that seemed to work but this centralized thing if it could do the handling of that would be really cool.

 

[JB_1366]

So this is a great script @JB_1366 !!
- do you think you can enhance it to actually transition or kick devices that seem to get stuck - Roaming assistant stinks =( It never actually does the kicking of certain devices - even with the threshold set to obscenely low numbers or vice versa very high numbers. I created on each node a script that would issue a bss transition and that seemed to work but this centralized thing if it could do the handling of that would be really cool.

I will look into it, as i would also like this.