merlin

  • SNBForums Code of Conduct

    SNBForums is a community for everyone, no matter what their level of experience.

    Please be tolerant and patient of others, especially newcomers. We are all here to share and learn!

    The rules are simple: Be patient, be nice, be helpful or be gone!

  1. P

    Cant flash RT-AX82U gnuton

    Hello, I have a RT-AX82U V1 with stock Firmware-Version:3.0.0.4.388_22525 It doesnt matter which merlin gnuton version I choose, its always says "failed Can anyone help me? kind regards
  2. Olndo Pindaro

    Entware atmt freeze on entware installation

    RT-AX86S - Merlin 388.2.2 try to install with AMTM entaware terminal freeze here. I can do? (for installing i used the diversiti site option) Thanks Olind0
  3. S

    Solved Serious Diablo IV Lag when using ethernet connection. HELP!

    I am running a GT-AX6000 on Merlin 388.2. When the computer is directly connected to the router with an ethernet cable I get horrendous lag spikes every 20-30 seconds or so. It will take my frame rate from 180fps down to 20-30fps for a couple of seconds and then it goes away only to do it...
  4. B

    OpenVPN TLS Error: tls-crypt unwrapping failed

    Hello! I can't connect my OpenVPN client on RT-AC68U router (Asuswrt-Merlin version 386.11) to OpenVPN 2.5.5 (linux) server. I couldn't connect even after I changed the default port and protocol to 55777/TCP. But: I tried to connect from a smartphone with the configuration file as below...
  5. J

    Dual GT-AXE16000 Routers in AiMesh Configuration extremely unstable

    Hi, I have two GT-AXE16000 routers. One primary, and one that I was trying to use as an AiMesh node. The problem I'm getting is that the node constantly resyncs and restarts wireless (as seen in its log), with only a few seconds of actual uptime in between each resync. This results in an...
  6. BreakingDad

    Let's talk about Twingate

    https://www.twingate.com/ Would it be possible to run this on the router? apparently it can run on a pi? Would it work as an AMTM addon? looks like a tiny install. Is it safe regarding Twingate being in control of the controller? Trusted by some small businesses, Safe for home use...
  7. U

    Merlinwrt + Mullvad OPVN + NextDNS

    Hey there, sorry if this has been answered before - I have looked and can't find a similar question. I'm not a networking expert before I begin! have just upgraded to MerlinWRT and Mullvad is my VPN of choice. As a side note I'd like to use wireguard but they only have instructions for openwrt...
  8. W

    Inadyn with dedyn/desec

    I'm trying to setup a dyn dns service called deSEC. I have a dyn subdomain sub.dedyn.io. In the newest version of inadyn, deSEC will be supported, but there is an older version in Merlin's firmware. So I need to make a custom config. In /jffs/configs/inadyn.conf.add I have a couple of extra...
  9. talha_rafiq

    AiMesh on Assus ac3200

    Hi, can we achive AiMesh technology on assus ac3200 in anyway ? by default AiMesh is not available in ac3200.
  10. fsb

    Upgrading, possible to export OpenVPN settings?

    Currently have an RT-AC86U (with NextDNS CLI for devices not routed thru the VPN) and upgrading to a new RT-AX86U. I'd like to minimize the amount of manual rework as possible when setting up the new router. I have about 50 different rules in VPN Director and 8 different OpenVPN clients setup...
  11. I

    RT-AX86U don't get proper WAN IP after power outage

    I have a modem running on bridge mode and every-time there's a power outage my RTAX86U (version 386.7_2) gets a local WAN IP instead of a public IP. It should be getting like this below. But the router stops doing the query once it gets an IP even tho a local IP which don't have internet access...
  12. SirLouen

    Support for ASUS XT8

    I've noticed that in the last version XT12 was supported by Merlin but I see that XT8 is not supported yet and I have not seen any threads talking about this Any plans on supporting this device?
  13. J

    OVPN Client throughput on ax88u Pro

    Anyone running an OVPN client on an ax88u Pro yet? What kind of speeds are you getting ? Where do you top out? Thanks!
  14. S

    USB failed on Ac68U

    Hi, Looks like my attached usb drive may have bitten the dusk. I am getting the following errors and my cpu cores are both constantly at 100%. DNS to website loading is taking a long time. What is the best way to go about replacing a currupt usb with minimal disruption ot he rest of my set...
  15. R

    AC86U - merlin 386.10 VPN

    I had been running 384.19 on AC86U for a number of years as I had various problems with updates after that build. I took the leap to upgrade to 386.10 yesterday and it would appear the issues I had with previous updates have gone. As the VPN section now has the VPN Director to control device...
  16. M

    Setup IPv6 in the LAN and route it to VPN

    I didn't find similar discussion and sorry if I still do not understand IPv6 well. Is it possible to setup VPN Client with IPv6 support and also support setup IPv6 in the LAN? In other words: Task: To get to some privacy by not disclosing real location (Real IP) and get rid of NAT by supporting...
  17. Sp0X

    Will 388.2 be on the AX-5400?

    Hello @RMerlin . Will there be an adaptation of 388.2 for the AX-5400? As I understand it, the AX-5400 in terms of components is a copy of the RT-AX58. Previously, the fork was done by @GNUton , but the last time he visited the forum was in February and now he is not active either here or on...
  18. J

    Skynet v7.3.6

    Is there a change log someone could point me toward, (if there is one)? Or else, anyone update yet? Please and thank you!!
  19. Sp0X

    Low wan speed with VPN director enabled

    Hello everyone. Forgive me for possible errors in the text, I write through a translator. A question arose about the work of the VPN Director. There are no errors in the logic of its operation, the traffic is redirected as it should. But the speed of WAN, which is the Internet not through a VPN...
  20. T

    How to monitor USB disk activity.

    Greetings! I'm running an RT-AX86U with the latest Merlin firmware. Can anyone explain how to monitor USB disk activity? I hear my USB drive clicking away all the time even though no devices are connected to the router. I have physically unplugged the WAN connection and the activity continues...
Top