How do I verify the security mode is working?
I went through the security pairing process by holding down the security button, the LED blinking did not start until I release the button. I did the same on the other unit to make it started blinking. It turned solid green in about a minute or so.
The bridge is connected & working, but I am not certain if the security mode is on or not.
I installed the Netgear utility on my Macbook. The Security panel shows that the remote unit's password is not entered, but I don't see any indication of the security status. The main page does indicate the Network Type is private. Is that it?
TIA
I went through the security pairing process by holding down the security button, the LED blinking did not start until I release the button. I did the same on the other unit to make it started blinking. It turned solid green in about a minute or so.
The bridge is connected & working, but I am not certain if the security mode is on or not.
I installed the Netgear utility on my Macbook. The Security panel shows that the remote unit's password is not entered, but I don't see any indication of the security status. The main page does indicate the Network Type is private. Is that it?
TIA