Hi,
I would like to replace my current Internet router from my provider with an ASUS RT-AC88U. So I want to connect this ASUS RT-AC88U directly on my NT-fibre box (not sure if NT is correct English). I would like to buy this Internet router and adding the ASUSWRT Merlin firmware as I am very impressed with the features I saw on www.asuswrt-merlin.net.
My Internet provider demands the following configuration for an Internet router.
• WAN Protocol: MAC Encapsulated Routing
• WAN1 1p/VLAN ID: 1/ 34
• WAN3 1p/VLAN ID: 5/ 4
• PPPoE passthrough function: Enable
• IP-adres: 192.168.2.254
• Duplex Mode: Auto
• Max Bit Rate: Auto
• DHCP Server, pool Start IP: 192.168.2.1
• DHCP Server, pool End IP: 192.168.2.252
Does the latest Merlin firmware supports this configuration?
Best regards,
Pieter
I would like to replace my current Internet router from my provider with an ASUS RT-AC88U. So I want to connect this ASUS RT-AC88U directly on my NT-fibre box (not sure if NT is correct English). I would like to buy this Internet router and adding the ASUSWRT Merlin firmware as I am very impressed with the features I saw on www.asuswrt-merlin.net.
My Internet provider demands the following configuration for an Internet router.
• WAN Protocol: MAC Encapsulated Routing
• WAN1 1p/VLAN ID: 1/ 34
• WAN3 1p/VLAN ID: 5/ 4
• PPPoE passthrough function: Enable
• IP-adres: 192.168.2.254
• Duplex Mode: Auto
• Max Bit Rate: Auto
• DHCP Server, pool Start IP: 192.168.2.1
• DHCP Server, pool End IP: 192.168.2.252
Does the latest Merlin firmware supports this configuration?
Best regards,
Pieter