qos

  • ATTENTION! As of November 1, 2020, you are not able to reply to threads 6 months after the thread is opened if there are more than 500 posts in the thread.
    Threads will not be locked, so posts may still be edited by their authors.
    Just start a new thread on the topic to post if you get an error message when trying to reply to a thread.
  1. B

    RT-AC86U wired WAN-LAN throughput with/without QoS (stock fw)

    Recently upgraded my ISP service to 300 Mbps down / 10 Mbps up. Running a web-based speed test from my ISP's server (WAN side) on a desktop PC wired to LAN port of my Asus RT-AC86U I typically reach 20% above provisioned ISP speeds with QoS off, but as soon as I enable any QoS features on the...
  2. E

    Adaptive QoS does not show in GUI, AC68U 386.1 Beta 2

    I cannot enable Adaptive QoS, the only options are "QoS"and Bandwidth Limiter, as shown in the image below: I have done a factory reset after installing.
  3. tbrock47

    General Question regarding DMZ and QoS

    So I have a basic question that I was unable to answer via my Google sleuthing. How do the DMZ and QoS work together when both are enabled on the router? I have a device in my DMZ that I also want to have a fairly high priority in the QoS hierarchy. I have a feeling that DMZ devices are either...
  4. N

    RT-AX58U QoS does not limit upload

    My internet connection is cable 100/5. I was using RT-AC68U before with Merlin firmware with these settings: Adaptive QoS, fq_codel Cable(DOCSIS) 18 WAN packet overhead Manual limit: 80 / 2.5 It was working pretty good. --- Recently I `upgraded` to RT-AX58U. Installed Merlin, did the same...
  5. I

    Game Accelerator vs QoS

    Hello. I have an Asus RT-AC68U and I just updated the Merlin firmware from version 384.13 to version 384.19. Yes, I know, it has been a while since the last update. I'm a little bit lazy... Well, before the update I had the QoS configured to prioritize my gaming PC over all my home devices. And...
  6. Kashif Tasneem

    Dual WAN Load Balance or Fallback?

    Hi guys. I have 2 internet connections. Primary Internet connection is 50 Mbps while secondary is 20 Mbps. I am confused whether to enable load balance or fallback in Dual Wan. I would love to enable Load balance but it disables AI Protection, QoS, Traffic Analyzer and Bandwidth Monitor. My main...
  7. dave14305

    FlexQoS FlexQoS 1.0 - Flexible QoS Enhancement Script for Adaptive QoS

    This is FlexQoS, a fork of the original, groundbreaking FreshJR_QOS script written by @FreshJR. FlexQoS provides a fully customizable Adaptive QoS experience. This thread is now superseded by Version 1.1 posted in this thread. Version 1.0.6 - 20-Nov-2020 Enhancements: Support for at least...
  8. T

    CakeQOS CakeQOS-Merlin

    I am pleased to announce the release of CakeQOS-Merlin! Discussions (due to thread closure): https://github.com/ttgapers/cakeqos-merlin/discussions Current Version: 1.0.7 (Changelog) CakeQOS-Merlin is a custom add-on for supported Asus routers with Merlin firmware that introduces CAKE QoS as...
  9. LongRangeSkeet

    RT-AX58U FQ_Codel issues

    Hi everyone, I just picked up this router today and set-it all up and enabled the FQ_Codel in the Adaptive QoS settings page. I'm provisioned at 200/10 by my ISP and Speedtest.net/Fast.com usually shows it hovering around 230+/12+ with zero % packet loss. Bufferbloat is F. The QoS...
  10. D

    [QoS] Bandwidth Monitor Tab vs Qos Tab : Need explanation please

    My Router Model : ASUS RT-AC68UF My Asuswrt-Merlin version : 384.17 Hi Everybody, I have a question about how QoS works. When we look in the "Bandwidth Monitor" tab, we can see that we can assign priorities to the different devices (highest, high, etc ...). => First prioritization When we...
  11. solstyce

    how to debug an iptable problem?

    I'm an iptables savage - I know just enough to know how thoroughly I could ruin my network configuration, and could use some help. I've tried to wrap my head around iptables several times over the years, and each time stagger away with a headache. I've run into a problem where my AC68U drops...
  12. S

    Guest Network B/W Limiter vs QOS Bandwidth Limiter

    RT-AC68R v384.17 firmware: If I enable the Guest Network bandwidth limiter feature, does the Adaptive QOS->QOS->Bandwidth Limiter (per MAC/device) table override the Guest Network limits? That is, if a device listed in the Adaptive QOS bandwidth limit table uses the guest network, which...
  13. J

    AX88U QoS not limiting upload speeds

    I recently purchased a AX88u and installed 384.16. My ISP speeds are 350 down and 30 upload. Set QoS to adaptive: fq_codel: upload 25: download 330:. Using dslreports, download is being limited (good bufferbloat) but see no change on upload (bad bufferbloat). Tried setting in traditional QoS...
  14. xendi

    What Data Is Sent to Trend Micro For Each Of These Features?

    Hello wonderful people. Upon setting up a new router, I was confronted with the following message: "By using AiProtection, Traffic analyzer, Apps analyzer, Adaptive QoS/Game boost, Web history, you agree to the Trend Micro End User License Agreement. Please note that your information will be...
  15. S

    Dual WAN device to run OpenVPN and QoS

    I hope you are all staying safe out there. I need some advice. Currently the office has a 45/15Mbit connection and a Celeron based QNAP running OpenVPN configured as split-tunnel and this just isn't enough to support 10+ staff working from home. There are about 6 RDP (Home PC>OpenVPN>Office PC)...
  16. N

    QoS Bandwidth limit issue

    I have problems with Merlin version 384.15 When I choose QoS Bandwith Limiter and choose 5Mb/s down and 5Mb/s up I get 500kb/s and when I change to 8Mb/s than I get 800kb/s 5 or 8Mb doesnt get limited to Mb but Kb
  17. P

    Bug?: Bandwidth monitor not functioning correctly under OpenVPN

    Running: 384.16_beta1 on a RT-AC3100 When I use the VPNClient to connect to my VPN server (openVPN) the QoS - WAN/LAN Bandwidth Monitor page shows all the traffic on the upload side only. Not only the upload gauge but the client entries below the gauges only show the upload bar moving. I...
  18. LongRangeSkeet

    QOS/AQM on RT-AX88U

    Hello all. I've been looking for a replacement router that primarily has good Active Queue Management features and came across the RT-AX88U. I've used stock firmware on ASUS routers in the past but I do not have any experience with Merlin. I couldn't find any answers to my questions while...
  19. B

    How Many Types of QOS Are There?

    Between marketing jargon and technical descriptions, every time I turn around there's some new type of QOS. Please help my confused brain! Regardless of what it's called, I (think I) understand that there are basically three kinds of QOS: priority based = high/medium/low; bandwidth based =...
  20. A

    RT-AC3200 won't let me disable QoS in the GUI. Is there a line command?

    So for some reason I am unable to shut off QoS in the RT-AC3200 GUI. I click the slider to off but when I click APPLY button there is no action. Using Web Developer in Chrome I can see there is a javsacript error of some kind. Same thing in firefox so not browser or extension specific. I...
Top