What's new
By:

  • SNBForums Code of Conduct

    SNBForums is a community for everyone, no matter what their level of experience.

    Please be tolerant and patient of others, especially newcomers. We are all here to share and learn!

    The rules are simple: Be patient, be nice, be helpful or be gone!

vlan

  1. Kanji-San

    AiMesh and guest WiFi on node

    Currently AiMesh nodes do not support guest WiFi. I have two RT-AC68U (384.17), one as a router, the other one as the AiMesh node. I would like to have the same guest WiFi on the AiMesh node as on the router with the guest clients being isolated from each other and the internal network. This...
  2. G

    VLAN tagging with stock firmware

    Hi all I definitely need a new router, as my AC56U with Merlin fw is at the end of its life (clients randomly loosing internet connection, web interface not reachable and so on). My setup is now made by a FritzBox 7530 is managing VDSL/VoIP/DECT (doesn’t support bridge, my VDSL provider does not...
  3. H

    IEEE 802.1Q for RT-AC66U_B1

    Hi, If I make a TRUNK port on the switch and mark all traffic using IEEE 802.1Q tags, does the ASUS RT-AC66U_B1 understand the router? I uploaded the latest Merlin FW to this router. I ask because I found no mention of tagging. Thanks for the anwers
  4. G

    Looking for a RT-AC56U substitute

    Hi all I'm looking for a substitute for my 5 years old AC56U. I had no big problems so far with it, but I now begin to see it's limit with my increasing (30 devices so far, 25 static DHCP entries, 5 port forwardings,2 guest networks, AB Solution ad-blocker, NTP server,VLANs) home network. I...
  5. B

    RT-AC5300: SPAN/bridge eth1 (WLAN) port

    Wireless Router Mode Firmware 384.15 Hello and thanks for allowing me to participate in SNB forums! I'm an IT admin with pretty good grasp of networking/linux/etc and am trying to solve an issue and could use some advice: I run a packet analysis platform whose capture interface does not have...
  6. W

    CPU high usage AC1900U/AC68U. VLAN related?

    Hello! I have just installed a AC1900U (AC68U) in my home. I’ve carried out a pretty basic installation, 3.0.0.4.384.45717 . A hard reset plus define SSIDs, remove upnp, define some static Ip and that’s all. No Aimesh, Ai protection or openVPN. The only relevant configuration apart from the...
  7. H

    LAN - Route

    hi, I have a smart switch on which I have several VLANs, including ACL rules. ASUS router RT-AC66U-B1 with the latest version of merlin FW is connected to VLAN10. In the router RT-AC66U-B1 on the LAN - Route tab I have set routing rules for individual VLANs. In the switch I have set the traffic...
  8. JensM

    NAT acceleration in AP mode?

    Sorry for opening 2 threads in a short time but this is not related to my other post. I have an AC66U with Johns Fork running in AP mode. When setting up multissid with vlan tagging (the tags then are send to my opnsense which is doing the rest) I had a big issue. When first connecting to any...
  9. JensM

    Is there a limit of number of bridges / vlans?

    After switching to opnsense as my mainrouter, I'm using my AC66U (running Johns Fork) in AP mode. I'm scripting it to tag different SSIDs and LAN-Ports with VLANs and send the traffic via a single connection to the opnsense what worked quite well for some SSIDs. For some others WPA2...
  10. M

    Topology/setup help - Mostly Asus-merlin devices

    Hi guys, guru, network and problem-solving lovers! I am requesting your help and wisdom here :) I know this question is mostly about topology but my devices are mostly using Asus-merlin and I believe the solution to my questions could be solved using the firmware. My situation is as follows...
  11. fantasydreamerforever

    Wireless VLANs on Asus RT-AC88U

    Hey all, I was trying to assist in getting some VLANs set up on a friend's network to segment off their IOT devices, but they keep all their IOT devices configured on the main wifi, and I'm not 100% on the best approach to take for segmentation in this instance. I'm trying to avoid encouraging...
  12. B

    IOT security question: Seperate a Smart TV from rest of network.

    I hope can explain this correctly. My goal is to separate a Smart TV IP Address from the same IP range as the rest of our home network. Currently I have an ADSL modem that is acting purely as a bridge to the ISP provider and that is all it does. Then I have a consumer router (Netgear r6250)...
  13. skeal

    [RESOLVED] Need basic port based vlan help

    Hi I have three TL-SG108E smart switches. Named as: North, South, and Main. On North and South I have identical settings. 2 x 802.1q port based vlans. They are setup, one has a PVID of 2 the other 8. I setup two 802.1q vlans on the Main switch to separate the North and South switches, all...
  14. G

    VLAN or Isolated LAN for IP Cameras using ASUS RT-AC68U?

    First off, not sure if this is the best route, but I do have an ASUS RT-AC68R (same is U) for my router. What I want to do is setup a VLAN or Isolated LAN, also heard it called a Walled Garden, for my IP Cameras. I see people talking about it but no actual setup descriptions or instructions...
    • g725s
    • Thread
    • asus rt-ac68u blue iris ip cameras isolated lan vlan walled garden
    • Replies: 22
    • Forum: Asuswrt-Merlin
  15. Yota

    Expand the Guest Network to two merlin routers

    Today, I will show you how to set up the same guest network on the primary router and the secondary router, and prevent the guest network from accessing resources on the LAN. What do I need? I have two RT-AC68U routers, they both flashed Merlin 384.14_2, One is running router mode, the other...
  16. C

    Network design help with 2sites, VPN and VLAN - Unifi

    Hi all I'm going to make my 2 site network design a big more secure/segregated and need some advice. See below for the basic idea. But I am no network expert at all, so maybe (most likely) will simply not work. What I want: the 3 'profesional' networks (2 sites and VPN) need to be...
  17. G

    Buying Advice with specific requirements

    I would really appreciate the communities advice. I have been a BT customer for about a decade, and I am currently on BT Superfast Broadband (FTTC) and found the Smart Hub (and previously the Home Hub) to be unreliable so have been using my trusted Cisco 887 workhorse for many years, however it...
  18. S

    For the millionth time, vlan/separating IoT setup

    Hi there, so I’m sorry to be the one to ask the same question over again. Unfortunately, I am a little confused in regard to vlans. Basically, I have a PC, NAS and Nvidia Shield Tv that I would like to be on one network. Separate from this I would like to have the, more or less, unsecure...
  19. L

    Tagged VLAN ping router but no internet

    Hi - Can anyone help me with this configuration. I have an L2 tagged VLAN (20) which can ping all it's peers and the router @ 10.1.1.1, it can even resolve DNS via the router but it cannot connect to the internet, I'm at a loss as to why. All my devices connect through port 1 on the Asus N66U...
    • law1213
    • Thread
    • asus n66u tagging vlan vlan tagging vlan tagging internet access
    • Replies: 3
    • Forum: ASUS Wi-Fi
  20. wpte

    [RT-AX88U] Help setting up routed IPTV

    I'm facing a problem with a recent setting my provider KPN (from the Netherlands) changed for their interactive IPTV boxes. Right now the setup is in bridged IPTV mode, where I simply just pass VLAN4 untagged to the IPTV box. (see attachment) But, what they changed recently is that you'd need...
Back
Top
✖