Beta Asuswrt-Merlin 3004.388.10 Beta is now available

[aex.perez]

Dirty Flash from 9.2, to 10 Alpha 1, to 10 Alpha 2 (AX88u) now on the Beta. Small hiccup with USB/SSD Flash drive Mounts but that was dues to a USB (no Flash drive) that had a problem I didn't catch before the upgrade. Took a bit to load on the nodes, half as long on the router. But on the router it took a few minutes to quiet down but suspect that was as a result of the mount points getting renamed. Once I fixed that, and restarted and the affected scripts came up clean.

Been fine since.

 

[RMerlin]

Enabling upnp on ax86u doesnt work manually port forwarding is fine.

Works for me.

 

[RMerlin]

I just flashed this on an AX88U and almost everything works fine. Only problem, I cannot change the options at the bottom of the Administration - Tweaks - Advanced Tweaks and Hacks section. After applying it will just sit there saying "Applying Settings..." infinitely.

Confirmed. This is caused by leftover from the legacy cstats daemon that does not exist on any of the currently supported models, I will have to remove that portion of the code.

 

[DiGz_Au]

Works for me.

View attachment 68017

Edit: with some testing, 388.9 works flawlessly with upnp. Anything after this including stock with upnp disabled windows doesnt like. Can anybody else do some testing? Specifically with call of duty on pc as any firmware that has upnp disabled by default doesnt seem to work correctly. Upgrade without wipe works from 388.9 to 388.10 with nat being open.
Doing a restore via router on latest firmwares sets upnp to disabled by default and when enabling this is where the issues start. Enabling Upnp seems good, the log shows the port being forwarded but windows is not getting the port opened.

Screenshot-2025-09-23-134718 hosted at ImgBB

Image Screenshot-2025-09-23-134718 hosted in ImgBB

ibb.co

= 388.10 beta

Screenshot-2025-09-23-135717 hosted at ImgBB

Image Screenshot-2025-09-23-135717 hosted in ImgBB

ibb.co

=388.9-2

 

[RMerlin]

Upnp seems good, the log shows the port being forwarded but windows is not getting the port opened.

Could simply be Windows not realizing that UPnP has been re-enabled. Try rebooting your computer after enabling UPnP on the router.

Bottom line, there hasn't been any change to UPnP in many months. The only change in 388.10 is that if you do a factory default reset, then it will be disabled by default.

 

[DiGz_Au]

Could simply be Windows not realizing that UPnP has been re-enabled. Try rebooting your computer after enabling UPnP on the router.

Bottom line, there hasn't been any change to UPnP in many months. The only change in 388.10 is that if you do a factory default reset, then it will be disabled by default.

Already tried multiple resets and even another Windows install on another disk. Hopefully somebody else on windows with a fresh install of this beta on ax86u or similar can test using a game.
I've just stayed on a dirty flash from latest non beta to this beta and with upnp already being on its all working fine.

Fresh latest stock fw also upnp doesnt work on windows. I've found others using different models stating the same that upnp is broken.

 

[tyreman]

Updated okay so far run a pretty vanilla system

 

[Unetwork]

Yes. Because you don't have any IP addresses configured in LAN - DHCP Server > DNS Server 1 or DNS Server 2.

Thank you for taking the time to answer my questions.
That's what I had partly understood.

So I will reuse the same settings as you say.