router

I want to prevent Router 2 from pinging all my devices. I want only internet access there. (Router 1 My network) (Router 2 Isolated/Guest Network) I tried to apply some Firewall Rules like mentioned here in Post #7: Click here but if I apply them on the Main Router (Router 1) my Internet...

Hi, I live in a rural area and have slow DSL internet which is shared between way too many devices these days.... I'm looking for recommendations for a router which will fulfill all the following requirements: Gigabit ethernet ports - no minimum number required Ability to set device-specific...

I'm looking for a router that supports: 4 x 1 Gbps ports At least 2 OpenVPN clients AES-NI for faster OpenVPN performance - preferably 200Mbps+ Asuswrt-Merlin I've been looking at the RT-AX68U, RT-AX86U, RT-AX86S and RT-AX92U. WiFi, mesh and 2.5 Gb support is not needed. Would the RT-AX68U...

I have a Tenda f3 (V4.0) router i think this is current latest, using it as main router, a wire coming from my isp directly to the modem, isp have a fiber modem near my house from which a ethernet cable attaches to my router (f3), it requires a username and password to access internet (i tried...

I have a somewhat odd network configuration that I'm hoping the wizards here can help me get working as I need. Here are my requirements: I need to be able to remotely (within my house) enable & disable the wifi network. I want this to happen without exposing my router to the internet via...

Hello everyone! After quite a few frustrations on issues with a commercial home mesh while working remotely, I'm going to take the plunge and build out my own - And I'm looking for help in deciding given all of the choices for router distros. My current environment: I have cable internet...

Hey all, I live in a home that is one floor approximately 2,000 sqft in size (high ceiling) with an approximately 2,000 sqft screened-in pool outside, perpendicular to and on the corner of the house. At the moment, I use an Arris TG1682 modem+router combo to deliver internet, however, it only...

I have two RT-AX92U routers. They are almost perfect for what I need. Both of them are in the basement and it mostly covers the main floor as well. They are wired backhaul. However, there are a few spots that are a bit flaky for signal strength on the main floor so I purchased a used...

Hey peps of SNB forum! First time poster and beginner at networking- and NAS systems. I’m playing with the idea of setting up a NAS coupled with my home router, either a prebuilt by Synology, Qnap etc; or a diy system running some dist of Linux. Either way, my question is the following: Say I...

OK all you routing geniuses I have a RT-AC68R running the newest Merlin Firmware, and I am half way to my dream setup I currently have a OPEN VPN server running amazing well and my phones can easily access all my files and network resources. I also have a Proton VPN instance set up on my Router...

Dear all, I am returning after more than 4 years. A lot struck me - good and bad - before the Pandemic played a hard ball on all of us. Long story short, happy to be in a "not too bad" moment! :) I am sorry as the post will be repetitive (my old post and a lot of similar ones) and I cannot...

The good news: At home, we have Comcast gigabit internet and I am using a new Arris S33 (2.5 Gbps port) modem and a new Orbi RBK853 (2.5 Gbps WAN) mesh system. The system is rock solid on wifi with tons of devices on the network! I can work from home for months on end and never have a connection...

Hello there, After quietly upgrading the firmware of my RT AC68U from the 386.2_2 to the 2_6, It is now bricked. What I tried: - Sha is correct so file is the right one - reset/reboot/nvram flush with WPS. Did not worked - enter Rescue mode and use the recovery tool to upload the Asus firmware...

Hi! So i have 2 AX11000 in AiMesh mode, i have the node connected by ethernet backhaul to the main one using the 2.5G port, because i have dual wan (2 ISP´s) in balance mode (1000 mbps + 600 mbps) so triying to get the most out of it via wireless, but the node gets disconnections a couple times...

Hello. Nice to meet you! I ask you – Did I make the right choice? Please read and please respond with a simple yes or no answer and if you could explain why you feel I did or did not and what you would have done. Last week, I purchased a new router from Amazon.com. It is the TP-Link A6 V3...

I'm about to sign up with TorGuard for its dedicated IP for streaming services. The windows client has a UI that allows you to select which IP you're using, but I'll be using the streaming IPs on non-windows devices so I won't have access to that app. Right now I need to configure this for a...

I held off an upgrade pending a decision between cable or fibre and finally went for the latter and a 150mbps service initially. I will purchase a new router before the install early June. I was considering the AC86U (bang for the buck) though want to make sure it can last me a few years...

Dear all, Regarding the image below, I was thinking it will be time for a router upgrade in the near future. Just need to save some money. Currently using the Asus AC68U with Merlin firmware on a Gigabit connection. At the moment I do not own any WiFi6 devices, but that may change later. :)...

I have a "main" router (router #1) connected to a modem and thus the Internet. This router can be accesses by anyone in my small business. But I also do some sensitive office work that I would like to keep private and thought of attaching a second router. Router #1 is a NightHawk x6s AC3000 and...

Hello, As a backstory: I live in UK and because of Brexit, the UK is no more part of the Digital Single Market, thus I can not access streaming services I pay for in my home country due to geo locking (not Netflix). To come around this I want to get a VPN router, get a VPS in home country and...